VehiclesHPI Racing Jumpshot SC V2
HPI Racing
HPI Racing Jumpshot SC V2
1/10 scale · 160261
- Final drive
- 14.40:1
- Tire
- 112mm
Open in Top Speedsourced
Specifications
Last modified
| Spec | Value | Basis |
|---|---|---|
| Drivetrain | ||
| Pinion | 17TStock | Stock |
| Spur | 90TStock | Stock |
| Transmission & axle | 2.72:1Stock | Stock |
| Spur ÷ pinion | 5.294:1Calculated | Calculated |
| Final drive | 14.40:1Stock | Stock |
| Wheels & tires | ||
| Tire diameter | 112mmEstimated | Estimated |
| Rollout | 24.4mm per motor turnCalculated | Calculated |
| Power | ||
| Motor | Not published | |
| Battery | Up to 2SLiPoStock | Stock |
| Performance | ||
| Theoretical top speed | Not published | |
| Vehicle | ||
| Part number | 160261 | |
| Scale | 1/10 | |
Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Not published means it exists but no source we could find prints it.
How these numbers were settled
Short-course version of the Jumpshot V2. Gearing is from HPI's printed chart; the tire OD is the only inferred figure - HPI lists the Jump SC tire as 2.2in/3.0in fitment with no diameter.
Sources
- stdhpiracing.com (opens in a new tab)
- Manual (PDF)hpiracing.com (opens in a new tab)
- 116522hpiracing.com (opens in a new tab)
Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.