VehiclesHPI Racing E10 Touring Michele Abbate GRRRACING
HPI Racing
HPI Racing E10 Touring Michele Abbate GRRRACING
1/10 scale · 160334
- Final drive
- 7.48:1
- Tire
- 64mm
Open in Top Speedverified
Specifications
Last modified
| Spec | Value | Basis |
|---|---|---|
| Drivetrain | ||
| Pinion | 22TStock | Stock |
| Spur | 65TStock | Stock |
| Transmission & axle | 2.53:1Stock | Stock |
| Spur ÷ pinion | 2.955:1Calculated | Calculated |
| Final drive | 7.48:1Stock | Stock |
| Wheels & tires | ||
| Tire diameter | 64mmEstimated | Estimated |
| Rollout | 26.9mm per motor turnCalculated | Calculated |
| Power | ||
| Motor | Not published | |
| Battery | Up to 2SLiPoStock | Stock |
| Performance | ||
| Theoretical top speed | Not published | |
| Vehicle | ||
| Part number | 160334 | |
| Scale | 1/10 | |
Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Not published means it exists but no source we could find prints it.
How these numbers were settled
Grip/touring version of the E10 chassis, identical drivetrain to the E10 Drift; runs Vintage Performance rubber (26mm front, 31mm rear) instead of drift tires.
Sources
- stdhpiracing.com (opens in a new tab)
- 111277hpiracing.com (opens in a new tab)
- 102993hpiracing.com (opens in a new tab)
Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.